Q. What are the dimensions/height of my Goldring cartridge?
Answer:
Here are the approximate dimensions of diamond-tip to mounting-point height & distance, important for VTA and overhang adjustment respectively:
Related Articles
Elite - Q. Can I use a Goldring Ethos with my EAR 834P phonostage and Onkyo MT-2 step-up transformer?
Answer: If the transformer has a 24 ohm input impedance and load impedance of 47k, it would have a gain of 44 which means that the output of the an Ethos would be stepped up to 22 mV. This might be too much for the EAR pre amp which has a sensitivity ...Eroica H/LX - Q. What's the static and dynamic compliance of these cartridges?
Answer: The Eroica H/LX have an average static compliance of 18 mm/N and a dynamic compliance of 10 mm/N at 10 Hz which makes them compatible with tonearms of an effective mass of between 8–30g . As the cartridges are hand built, both these figures ...Goldring Eroica Cartridges - Instruction Booklet
For information on the setup and care of your Goldring Eroica cartridge, please see the attached document.Q. Which Goldring cartridge is better for treble and high frequency clarity?
Answer: Our recommendations would be to use either the Eroica LX or Elite. Goldring cartridges are designed to be flat, however all moving magnet (MM) cartridges, from any manufacturer, suffer from high frequency roll off due to the high input ...Legacy - Q. What is the stylus tip to mounting point height and distance?
Answer: The stylus tip to mounting point measurements for the Legacy cartridge are as follows Height: 19.9mm Distance: 8.1mm